Reproduction Rear Grille as used on early Espada’s

 

 The first few Espada's built had a rear grille on the vertical glass.  

The problem with the grille was that the factory needed to install it with 10 screws as it was weak structurally. When you wanted to wash the vertical glass you had to find a small screwdriver and spend some time.

My design has the same dimensions and looks as the factory but built stronger and only needs (4) stainless steel spring pins that have a small handle that you turn 90 degrees and pull to release the grille in seconds.

 

This 1969 Espada S-1 will be at the Concorso Italiano in Monterey if you would like to see it close up.

See You In Monterey!!!